Designs, develops, and tests electrical equipment, components, or systems* Perform Document Writing/Review/Correction- Technical Shop Support- Design Test Equipment and Tools* Perform First Article Inspection

Create and implement test procedures based on product requirements and customer specifications. Monitor testing and analyze data to verify performance of the product to customer and design specifications. Review and approve test reports.Conduct failure analysis examinations.Experience in analog and circuit design (digital is a plus), which includes ADC and DAC circuits design, DC – DC converter power supply design, constant current source design, FPGAs.Experience with LED drive circuitry, Pulse Width Modulation (PWM) dimming, signal conditioningHands on experience in bench top prototype circuit verification, PCB layout verification, familiar with electrical and electronics test equipment.Proficiency in design of wiring, cabling, shielding, noise management, transient suppression, electrical packaging, heat sinking, analog circuit designProficiency in frequency and time domain analysis, digital signal processingWorking knowledge of computer hardware design and interfacing; microcontrollers; embedded communication protocols (CAN, Ethernet, ARINC).Some knowledge of programmable devices (FPGA, CPLD).Working knowledge of various sources of electrical power: batteries, high efficiency DC/DC conversion, power budgeting, 3-phase AC.Testing and trouble-shooting of electronic units or sub-assembliesBasic experience with Enovia or other Product Lifecycle Management (PLM) tools would be a plus. Basic experience with SAP or other ERP/MRP tools would be a plus. Proficient in Microsoft Word, Excel and Power Points.Good documentation and communication skillsKnowledge of civil avionics digital interfaces (RS-232, RS-422, A429)Knowledge of civil avionics analog interfaces (thermocouple, synchro, shunt, etc) and discrete interfacesKnowledge of design of EMI/EMC protections for avionics productsElectronic testing tools (oscilloscope, multi-meter)Consciousness of the impact of the electronic design on the unit cost and part supply process (e.g. obsolescence)Basic experience with Enovia or other Product Lifecycle Management (PLM) tools would be a plus. Candidate without PLM experience will be trained.Proficient in Microsoft Word, Excel and Power Points.Good documentation and communication skillsThis position requires use of information or access to hardware which is subject to the International Traffic in Arms Regulations (ITAR). All applicants must be U.S. Persons within the meaning of ITAR. ITAR defines a U.S. Persons as a U.S. Citizen, U.S. Permanent Resident (i.e. green card holder), political asylee or refugee.